Αποτελέσματα Αναζήτησης
Just recently my first layers have stopped sticking to my build plates. Here is what I have done to troubleshoot. After each step, I attempted a new print. Re-leveled, and tested with different build plates. I have two build plates and prints are failing to adhere to both. Re-surface build plate.
I have had my Mars 2 for some time now, and recently for whatever reason, my prints are refusing to stick to the build plate. This isn't a new issue, previously my prints have been hit or miss for being successful but usually they print just fine.
15 Οκτ 2021 · Elegoo Mars Prints Sticking to FEP. While resin 3D printing, some prints may stick to FEP film which can get very frustrating. Your prints should come off the FEP film easily with the Z-lift and a pop sound when the remaining part of the surface detaches from the film.
15 Μαρ 2024 · Is your resin print not sticking to the build plate? Don't give up hope! Check out these six solutions for perfect adhesion!
I'm having a ton of problems with my Saturn 2. Every print breaks off the supports and sticks to the vat, unless I use so many heavy supports that I lose definition. Raft and supports print fine.
For the last week, I have seen a degradation on my printing, with prints not sticking to the build plate at first in the center, with still successful prints on either sides, leaving goo on the FEP film.
24 Νοε 2020 · If you are experiencing the "Model not sticking to the build plate" problem, please follow the steps below: 1.Check our official resin setting suggestions: CLICK HERE. 2.Level the build platform. Did you loosen the building platform screws before level the building platform?
