Αποτελέσματα Αναζήτησης
The 6.5 mm and 7.3 mm cannulated screws are available in six different instrument and implant sets, three with stainless steel screws and three with titanium. Each set includes the same set of instruments, but a different combination of two screw sets. Set Name. 6.5 mm Cannulated Screw.
- Screw
3.1.1.3 Lab - Install the Power Supply Introduction...
- Scoop Slide Instructions
Center the pieces. Screw one #12 x 1” hex head screw through...
- Screw
The DePuy Synthes 6.5 mm and 7.3 mm Cannulated Screws are intended for fixation of fractures, fusions, osteotomies, nonunions, and malunions of long bones and long bone
For 4.5 mm Cannulated Screws 292.72 1.6 mm Threaded Guide Wire, 150 mm 310.16 1.5 mm Drill Bit, 110 mm, quick coupling 311.59 Cannulated Tap, 180 mm 292.727 1.6 mm Non-Threaded Guide Wire, 150 mm For 6.5 mm and 7.3 mm Cannulated Screws 310.495 7.3 mm Cannulated Drill Bit, large quick coupling, 300 mm 311.689 Cannulated Tap, 275 mm
Introduction. Cannulated Compression Headless Screws (CCHS) System Overview. Titanium alloy (Ti-6Al-4V ELI) Self-drilling/self-tapping, headless design. Portfolio: 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.5, 6.5, 7.5 mm. Cannulated for using a guide wire. Diferential pitch in head and tip thread. Short and long thread lengths.
270 mm 311.689 Cannulated Tap for 6.5 mm/7.3 mm Cannulated Screws, 275 mm/200 mm 310.63 5.0 mm Cannulated Drill Bit, Large Quick Coupling, 300 mm, 2.9 mm Cannulation 319.70 Cannulated Screw Measuring Device 310.78 Cannulated Countersink 312.07 Variable Angle Wire Guide 312.08 8.5 mm/2.8 mm Wire Sleeve
Insert the appropriate cannulated screw using the cannulated screwdriver and the holding sleeve. Cannulated screw 4.5/6.5/7.0/7.3. Insert the appropriate cannulated screw through the protection sleeve using the hexagonal cannulated screwdriver. Next, re-move the protection sleeve. Remove and dispose of the guide wire.
ip in the bone could be compromised. Note:When the screw must be inserted at an. acute angle, the spherical washer can be used. The screw (6.5/7.0. 7.3) can be inserted at an angle of 0– 70°.It is recommended that the B 13.0 mm Drill Bit (351.270) and the B 17.0/15.0 mm Protection Sleeve (357.530) be used as the.
