Αποτελέσματα Αναζήτησης
17 Ιουν 2020 · Introduction to Networks v7.0 ITN - 12.6.6 Packet Tracer - Configure IPv6 Addressing.pka file: https://drive.google.com/file/d/1oBXs0dgf7FuchgnQFiNLevo85-4ay...
12.6.6 Packet Tracer - Configure IPv6 AddressingFor any Assistance WhatsApp: +918078212814Visit our Website: http://www.techacadhelp.comFollow us on Facebook...
24 Αυγ 2020 · Instructions. Part 1: Configure Dynamic NAT. Step 1: Configure traffic that will be permitted. On R2, configure one statement for ACL 1 to permit any address belonging to the 172.16.0.0/16 network. R2(config)# access-list 1 permit 172.16.0.0 0.0.255.255. Step 2: Configure a pool of address for NAT.
18 Απρ 2017 · Subscribed. 801. 73K views 6 years ago CCNA Routing and Switching: Introduction to Networks 6.0. This is the Packet Tracer activity of CCNA Routing & Switching Module-2 - Configuring IPv6...
In this configuration lesson, we will follow the below IPv6 Configuration steps: Enable IPv6 Globally. Enable IPv6 on Interface. Configure EUI-64 Format Global Unicast Address. Configure Manual Global Unicast Address. IPv6 Ping. Manual Link Local Address Configuration. Auto IPv6 Address Configuration. Enable DHCPv6 Client.
In this Packet Tracer Physical Mode (PTPM) activity, you will configure hosts and device interfaces with IPv6 addresses. You will issue show commands to view IPv6 unicast addresses. You will use ping and traceroute commands to verify end-to-end connectivity. Instructions.
Step 1: Create the Network Topology. Launch Cisco Packet Tracer and create a new network topology. Place multiple routers on the workspace and establish connections between them using appropriate cables, ensuring connectivity. Step 2: Configure IPv6 Addresses on Interfaces.
