Yahoo Αναζήτηση Διαδυκτίου

Αποτελέσματα Αναζήτησης

1. www.subaruoutback.org › threads › which-cv-axles-to-put-on-lifted-2001-outback-3-6Which CV axles to put on lifted 2001 Outback 3.6L

   www.subaruoutback.org › threads › which-cv-axles-to-put-on-lifted-2001-outback-3-6

   • Αποθηκευμένο αντίγραφο

   3 ημέρες πριν · Hello, I'm about to install a lift kit on my Outback. I should get 2" of lift in the front and 2.5" in the rear. Trouble is I'm concerned about the CV axles, as I'm on the edge of the acceptable lift for their angles, and I am moving (almost 3000km drive through pretty remote areas) and will put about the same mileage on them before I leave.

2. www.8thcivic.com › threads › brand-recommendation-for-knuckles-and-bearingsBrand Recommendation For Knuckles And Bearings?

   www.8thcivic.com › threads › brand-recommendation-for-knuckles-and-bearings

   • Αποθηκευμένο αντίγραφο

   2 ημέρες πριν · Mechanical Problems & Technical Chat ...

3. www.duramaxforum.com › threads › key-fob-programming-helpKey FOB programming help | Chevy and GMC Duramax Diesel Forum

   www.duramaxforum.com › threads › key-fob-programming-help

   • Αποθηκευμένο αντίγραφο

   1 ημέρα πριν · 1. close all doors. 2. hold driver's unlock button. 3. turn car on/off 2 times. 4. release unlock button. 5. press and hold lock&unlock on FOB for up to 30 seconds until locks cycle. This didn't work. I noticed that after step 4 the car would click twice, but it wouldn't actually cycle the door locks. I bought a new key fob online.

4. 67-72chevytrucks.com › vboard › showthreadHow does fuel pump cutoff work? - The 1947 - Present Chevrolet &...

   67-72chevytrucks.com › vboard › showthread

   • Αποθηκευμένο αντίγραφο

   3 ημέρες πριν · How does fuel pump cutoff work? The 07+ Chevy and GMC Message Board

5. www.s10forum.com › threads › fuel-pump-fuseFuel pump fuse | S-10 Forum

   www.s10forum.com › threads › fuel-pump-fuse

   • Αποθηκευμένο αντίγραφο

   1 ημέρα πριν · Fuel pump fuse. Hello I have an 1983 s10 2.8l and just replaced the tank as well as the sending unit in the tank but when I turn the key I can’t hear it turn on at all. I was wondering if there is a fuse or a relay somewhere I can check. As i recall and i may be way off the 1983 was a carb model. No in-tank pump.