Αποτελέσματα Αναζήτησης
29 Αυγ 2022 · Config files and binary for Creality Ender3 with BLTouch (Silent Motherboard v4.2.7)
BL Touch is an open-source auto-leveling sensor for 3D printers, designed to precisely measure and adjust the tilt of the bed surface with ease. Download the BL touch firmware here.
29 Αυγ 2022 · Firmware binary for Creality Ender3 with the silent (4.2.7) motherboard upgrade and BLTouch/CLTouch. To install, download .bin, put it on a micro sd card, plug the sd card into your powered off Ender3, turn it on and the new firmware will install
22 Ιαν 2024 · I have an original Ender 3 that has been upgraded as follows: 4.2.7 motherboard BL Touch Sprite Extruder Pro. The printer worked fine after I installed the new MB and BL Touch. After installing the new extruder and using the only firmware I could find that claims to support the touch sensor and Sprite extruder bed levelling doesn’t work properly.
14 Μαρ 2021 · Ender 3 Max Bltouch Setup & Firmware Installation 3. Here’s a simple guide on how to install BLTouch: Mount the BLTouch with the part 3D printed sensor mount or the part provided if you are using a kit. Turn your printer so you can access the electronics cover as well as access to the mainboard.
Marlin 2.0 takes this popular RepRap firmware to the next level by adding support for much faster 32-bit and ARM-based boards while improving support for 8-bit AVR boards. Read about Marlin's decision to use a "Hardware Abstraction Layer" below.
Custom Marlin firmware for a Ender 3 - v4.2.7 Board - BLTouch - 3D Printer, built daily to stay fresh.
