Αποτελέσματα Αναζήτησης
My build plate is slightly scratched, but not to any point where it should be causing issues with prints. I've changed my settings on lychee slicer for the resin I'm using - Anycubic Rapid Grey. This did help with the raft sticking to the plate, however this too stopped happening after a few prints.
Just recently my first layers have stopped sticking to my build plates. Here is what I have done to troubleshoot. After each step, I attempted a new print. Re-leveled, and tested with different build plates. I have two build plates and prints are failing to adhere to both. Re-surface build plate.
For the last week, I have seen a degradation on my printing, with prints not sticking to the build plate at first in the center, with still successful prints on either sides, leaving goo on the FEP film.
You may also want to try roughing up the platen with a scotch brite pad or some 600-800 grite wet sanding paper (do it with "wet"). I found that to greatly improve plate adhesion on my May of 2020 model M20Silver200401 machine. Yes, it might end up being the resin simply went bad.
I can't seem to get either of these resins to stick to build plate. I have tried changing setting in chitubox, put some wd-40 on the FEP, slightly roughed up the build plate and a lot of other stuff. Should I be going about things diffrently with these resins?
Οι πιο έγκυρες αστρολογικές προβλέψεις για τα όλα τα ζώδια Κριό, Ταύρο, Δίδυμους, Καρκίνο, Λέων, Παρθένο, Ζυγό, Σκορπιό, Τοξότη, Αιγόκερω, Υδροχόο, Ιχθύ.
Using the plastic scraper I got the failed prints off the film. They were perhaps 5mm high and solid. So clearly the UV light is working properly. My second print resulted in even less of a print, 2.5 hours later the build plate was hovering with uncured resin on it.
