Αποτελέσματα Αναζήτησης
Just recently my first layers have stopped sticking to my build plates. Here is what I have done to troubleshoot. After each step, I attempted a new print. Re-leveled, and tested with different build plates. I have two build plates and prints are failing to adhere to both. Re-surface build plate.
My build plate is slightly scratched, but not to any point where it should be causing issues with prints. I've changed my settings on lychee slicer for the resin I'm using - Anycubic Rapid Grey. This did help with the raft sticking to the plate, however this too stopped happening after a few prints.
For the last week, I have seen a degradation on my printing, with prints not sticking to the build plate at first in the center, with still successful prints on either sides, leaving goo on the FEP film. This then went on with only successful prints on only one side of the build plate. Now nothing prints.
15 Μαρ 2024 · Is your resin print not sticking to the build plate? Don't give up hope! Check out these six solutions for perfect adhesion!
24 Νοε 2020 · If you are experiencing the "Model not sticking to the build plate" problem, please follow the steps below: 1.Check our official resin setting suggestions: CLICK HERE. 2.Level the build platform. Did you loosen the building platform screws before level the building platform?
Using the plastic scraper I got the failed prints off the film. They were perhaps 5mm high and solid. So clearly the UV light is working properly. My second print resulted in even less of a print, 2.5 hours later the build plate was hovering with uncured resin on it.
16 Ιουν 2023 · To resolve resin prints not sticking to the build plate, it is recommended to increase the bottom exposure time by 10 seconds and add 5 additional bottom layers to the current parameters. This adjustment will ensure great adhesion and stability for the base layers of the model.
