Αποτελέσματα Αναζήτησης
26 Μαΐ 2015 · The no ip domain lookup command is usually seen in configurations. By default, any single word entered on a command line that is not recognized as a valid command is considered as a hostname by the router, and the router will by default try to telnet to that hostname.
This article describes the no ip domain-lookup command, which is used to disable the DNS translation process in Cisco IOS.
3 Δεκ 2012 · The no ip domain lookup command is configured. IP name server addresses are not configured. There are no valid interfaces or routes for sending to the configured name server addresses. If these conditions are removed, DNS spoofing will not occur. SUMMARY STEPS. 1. enable. 2. configure terminal. 3. ip dns server. 4.
15 Μαΐ 2023 · Set Up a Router to Use DNS Lookups. Your router can be configured to use DNS lookups if you wish to use the ping or traceroute commands with a host name rather than an IP address. Use these commands to do so:
7 Σεπ 2020 · By default, DNS lookup is enabled on the Cisco platform which causes delays in traceroutes and in a few other cases. You can simply disable it using the command : R7(config)# no ip domain-lookup
In order to disable DNS lookup, you have to type the below command in the global configuration of the Cisco device. [terminal]no ip domain-lookup[/terminal]This command helps you to prevent automatic DNS lookup in Cisco devices.
Use the ip domain lookup command in Global Configuration mode to enable the IP Domain Naming System (DNS)-based host name-to-address translation. To disable the DNS, use the no form of this command. Syntax
