Αποτελέσματα Αναζήτησης
The T3 Driver is designed to operate up to 30 GPM and 1500-3000 PSI. The driver is equipped with a hydraulic manifold with a flow regulator set at 15 GPM. The T3 performs at maximum efficiency (6 strokes per second) at 15 GPM. The unit is functional at a lower GPM but will operate with fewer strokes per second.
- T3 Driver
The T3 Driver will drive T-posts up to a 3" O.D. pipe at a...
- T3 Driver
The T3 Driver will drive T-posts up to a 3" O.D. pipe at a rate of up to six strikes per second. The top of the post is fully contained to prevent kick out and protected from damage by the strike plate. Use your tractor, skid-steer, mini-ex, loader, or backhoe to carry the weight of the driver.
22 Δεκ 2015 · I've just bought a old ZL2201 (L245) with the intention of getting a post driver & hole auger to run off the tractor. I would prefer to use a driver but unsure if my littl tractor is big enough to handle the weight/force of a driver.
Read this manual before using your Hydraulic Post Driver. This manual is provided to give you the necessary operating and maintenance instructions for keeping your Hydraulic Post Driver in top operating condition.
© 2024 Google LLC. This video demonstrates the new Danuser T3 Driver driving T-posts. To learn more visit http://www.danuser.com/attachments/post-drivers/t3-driver.
Category I and II 3-point hitch required; 50-degree side-side and front-back tilt; Impact: 120,000 pounds; Minimum hydraulic requirement: 15 GPM @ 1,500 PSI; When driving 4x4 or 6x6 square posts, we recommend drilling a pilot hole to help keep the post straight. You can also use the back corner of the beam as a guide for the post to help keep ...
Allows Driving Posts as Low as 6” Above Grade! Self-Contained Hydraulic System: Eliminates the clumsy & costly Return Line Kit (a nuisance to add & remove & route to the reservoir filler neck)!
