Αποτελέσματα Αναζήτησης
4. Attach and clamp 1-1/2 inch fill hose and 5/8 inch vent hose in accordance with the above referenced standards. 5. The vent system requires that the surge valve feels loose in order to operate properly. Remove two screws under cap to access flame arrestor screen for cleaning. NOTE: Plastic fuel fills should NOT be grounded. (1).
- Allow for adequate clearance under fill for routing fill and vent hose, which must be selected and installed in accordance with A.B.Y.C. requirements and U.S. Coast Guard Safety Standards for Small Boat Fuel Systems (33 CFR 183). - CONSIDER THE LIMITATIONS OF A MARINE FUEL VENT: DO NOT locate on a surface that can
1).The Tank vent must be installed in accordance with U.S.C.G. Safety Standards for Boat Gasoline Fuel Systems, #33CFR183 and A.B.Y.C. Standard H-24. 2). Locate the mounting surface with a thickness up to 5/8 inch maximum. 3). Drill a 1-5/8 inch diameter hole in the mounting surface. 4). Make sure the vent head is tightened against the threaded ...
5/16” hose which attaches to the barb of the same size, is a return line which goes back to the Travel Trekker™ tank in the event the vehicle’s tank over-fills. Proceed with installing the hoses and components as per the plumbing diagram in Fig. 12. Be sure to use hose clamps provided on all connections. Mount the pump as instructed in ...
APPLICATION. Installs into hull exterior and provides a splash-resistant thru-hull vent exchange. For hull thickness from .100" or 2.5mm (aluminum hulls) to 7/8" or 22mm. Designed to work on traditional tank vent systems with standard 5/8" I.D. (16mm) fuel vent hose. REQUIRED FOR INSTALLATION. Pencil • Marine-quality silicone sealant.
Eliminates the need to install a fuel line vent and a surge protector — now, one product helps avoid spills, provides fuel tank venting, and resists water instrusion into the fuel system.
flexible gas piping design guide and installation instructions industrial december 2016 residential commercial fgp-001 12/16 ©omega flex, inc.
