Αποτελέσματα Αναζήτησης
AISC_PART 16_A_Prelims.qxp_15th Ed._2016 2018-05-10 12:18 PM Page ii. 16.1-iii Specification for Structural Steel Buildings, July 7, 2016 AMERICAN INSTITUTE OF STEEL CONSTRUCTION PREFACE (This Preface is not part of ANSI/AISC 360-16, Specification for Structural Steel ... † Adopted an ASTM umbrella bolt specification, ASTM F3125, that ...
Significant additions to Glossary (bolting assembly, bolting component, bolt tension measurement device, calibrated gap, cure, initial tension, initial torque, job inspection gap, matched bolting assembly, spline end, sufficient thread engagement).
23 Σεπ 2020 · This 2016 edition of the Structural Bolting Handbook is based principally upon the June 2014 edition of the RCSC Specification for Structural Joints Using High-Strength Bolts, cited by the 2010 AISC Specification for Structural Steel Buildings (AISC 360-10).
11 Ιουν 2020 · RCSC Specification for Structural Joints Using High-Strength Bolts. This Specification covers the design of bolted joints and the installation and inspection of bolting components and bolting assemblies listed in Section 1.5. The Specification also considers the use...
For 2016, KL, the effective length, has been replaced with Lc. This makes the designation of effective length simpler since in some instances, such as for torsion, the traditional definition of K is not helpful. This has been implemented throughout the 2016 Specification. 17.
Nominal bolt lengths are tabulated based upon the grip for 3/4-in., 7/8-in., 1-in., and lH-in. diameter ASTM A325 and A490 bolts with zero, one, or two 5/32-in.-thick ASTM F436 flat washer(s) and an ASTM A563 nut; bevelled washers are not considered in this paper.
23 Νοε 2019 · For tightening bolts in structural connections, search AISC topics on "turn of the nut method". For pretension an embedded anchorages, the desirable pretension needs to be specified by the design engineer (20k, 30k, ...).
