Αποτελέσματα Αναζήτησης
what application, how to fit the hose ends and how the finished hose assemblies will fit to your project - all in one simple to read booklet. Almost everything you read here can be applied to AN hose and fittings that are supplied by all the well known names, not just Speedflow.
Determine the attachment point of the Weight Distribution Head (2) to the Square Shank according to the needed connection height calculated in step 1c. The Square Shank can be turned upside-down if needed. Each hole is 1-1/4" of adjustment. Insert one of the 3/4" Bolts (16) through the lower hole to hold the Weight Distribution Head in place ...
Dimensions of AN fittings, hose and pipes are some of the most common questions and misconceptions that exist about the AN system. AN is measured in inches where AN1 in theory is 1/16", AN8 is then 1/2" and AN16 is thus 1".
Installation Instructions (continued) Weight Distribution Head Installation SAFETY 1. Determine the required ball height: a. Divide tongue weight by 200 for tow vehicles with overload springs, divide it by 100 for vehicles without overload springs and multiply the result to calculate tow vehicle ‘squat’: _______ lb.
31 Δεκ 2014 · Quick reference tabels for AN fittings from -2 to -32 and Hose fractional equivalent charts.
5. Use thread seal tape on the hose fitting threads and screw the fitting onto the swivel and tighten. 6. Attach the Hose Stopper on the end of the Hose near the Outlet fitting. 7. Carefully release the Drum Latch and allow the Hose to wind onto the reel, evenly distributing the Hose across the Reel. PLEASE READ THE FOLLOWING CAREFULLY
Harbor Freight Tools
