Αποτελέσματα Αναζήτησης
The following command configures a range of interface as a trunk port for a set of VLANs: (host) [00:0b:86:99:88:17] (config) #interface range gigabitethernet 0/0/0-0/17. (host) [00:0b:86:99:88:17] (config-submode)#switchport mode trunk. (host) [00:0b:86:99:88:17] (config-submode)#switchport trunk native vlan 10.
use,orcopying.ConsistentwithFAR12.211and12.212,CommercialComputerSoftware,Computer ... commands 145 aaaauthenticationport-accesscaptive-portal-profile 145 showport-accesscaptive-portal-profile 146 url 147 url-hash-key 148 ... ipsource-interface 424 ipv6address 425 ipv6source-interface 426 mtu 427 persona 428
Configuration commands. router rip; Interface commands. ip rip; ip rip all-ip enable; ip rip all-ip disable; ip rip all-ip send disable; ip rip all-ip receive disable; Routing commands. enable; disable; distance; maximum-paths; redistribute; timers update; RIPv2 clear commands. clear ip rip statistics; RIPv2 interface commands. enable; disable ...
This guide provides the reference documentation for the CLI commands for the ArubaOS-CX network operating system.
Input the following commands to enter a range of VLANs. For consecutive VLANs, the following example uses VLANs 2-10. ftos(config)#interface range vlan 2 - 10. For non-consecutive VLANs, the following example uses VLANs 15 and 20. ftos(config)#interface range vlan 15 , vlan 20
This guide provides the reference documentation for the CLI commands for the ArubaOS-CX network operating system.
3 Ιουλ 2019 · Probably a very silly question: is actually possible to select, as example, a range of Interfaces (or a list of specific Interfaces) and execute a permitted command against that range/list?
