Αποτελέσματα Αναζήτησης
25 Σεπ 2017 · I assume that you have tried different scales of the hatch patterns. Is the file Metric or Imperial? Try running AUDIT on the file as well as PURGE. Then apply a hatch with different scales to see if it shows up. I am happy to look at the drawing file too to see if this is indeed the issue or if there is something else going on.
18 Σεπ 2024 · Issue: When viewing, plotting, or previewing a drawing in AutoCAD, certain hatch patterns do not display or display incorrectly. The same hatch objects may behave correctly when the drawing is opened in a different version of AutoCAD.
16 Οκτ 2024 · When using the HATCH or BHATCH command in AutoCAD, no hatch pattern is applied or displayed on the screen. The command initiates successfully, however, one or more of the following may occur: The process cancels or terminates unexpectedly. A chime or ding is heard.
5 Αυγ 2024 · Solution: New hatches. To prevent the issue from occurring on new hatches, follow these steps: Enter MEASUREMENT on the command line. Change the value to match the desired units in the drawing: 1 = Metric, uses the hatch pattern file designated by the ISOHatch registry setting.
This article focuses on the following situations that might occur when creating or displaying hatch objects: Valid hatch boundary not found. Hatch spacing too dense, or dash size too small. Hatch object isn't visible. Hatch preview and final hatch object don't match.
18 Ιουν 2021 · Issue: When Plotting files in AutoCAD. Some Hatches do not Plot and/or Preview, Display. Causes: This can happen for a number of reasons. Hatch detail. Fillmode. Hatch Scale. File Corruption. Viewport Corruption. Solution: Hatch Detail being too low or too high can cause this issue.
8 Οκτ 2023 · When you try to apply a hatch pattern to an object in a drawing that was created in a release earlier than AutoCAD® Release 12, the hatch does not appear when you use the HATCH or BHATCH command. Instead, the command ends without an error message. This problem occurs because FILL is set to Off in the original drawing.
