Αποτελέσματα Αναζήτησης
11 Οκτ 2020 · I'm installing a safety chain on my Ranger 330 V bass boat. safety hook, link, and chain at Tractor Supply: (PAID LINK) https://www.pntrs.com/t/SENKSUZITEZDS......more.
12 Φεβ 2023 · Considering with most vehicles today there's no way to actually adjust the rear suspension alignment unless you replace parts, some would argue a 4-wheel alignment really doesn't do much at all. There are some reasons to get a 4-wheel alignment over a 2-wheel alignment, though.
5 Ιαν 2008 · Finally got the tool for the engine alignment in my 3.0 Mercruiser. When I tried to align before it seemed that I couldn't get the right pitch by moving the front of the engine up and down. I have the spring type washer and fibre washer on the rear of the engine as per the parts book.
24 Αυγ 2009 · The quickest way to find "center" for the shaft is to move the coupler up & down, then left & right, center being half way for both. The trick is making the measurements and then 'fixing' the shaft to get a reference for the engine to get aligned to. My shafts are 1.5" OD and the ID on the log is 2".
23 Ιουν 2012 · With the front of the engine on a chain block and the lower nuts on the mounts wound all the way down, lower the engine slowly until the coupler appears to be pretty close to alignment (It's quite obvious when you're looking in).
3 Απρ 2023 · From there, go on deck and put that turkshead braid or loop of tape on the wheel's rim at 12 o'clock and tighten the wheel brake. Next, fold the chain in half to find the center link, and place that center link on the sprocket so that equal lengths of chain fall on either side of the sprocket.
All too often yards and mechanics will straighten shafts or align engines without looking at the strut bearing alignment. Struts can be out of alignment due to a poor factory set-up or a hard grounding causing a bent or twisted strut. This article covers the alignment of a strut with a fixed cutlass bearing.
