Yahoo Αναζήτηση Διαδυκτίου

Αποτελέσματα Αναζήτησης

1. www.speedguide.net › faq › what-cable-modem-signal-levels-are-considered-good-78What cable modem signal levels are considered good -...

   www.speedguide.net › faq › what-cable-modem-signal-levels-are-considered-good-78

   • Αποθηκευμένο αντίγραφο

   Most cable modems are incapable of transmitting higher than 51 dBmV (upstream power). For example, I've read the specifications sheets for the Arris SB6183, SB6190 and TM822. They all have a maximum upstream power of 51 dBmV.

2. broadbandlibrary.com › cable-modem-transmit-powerUnderstanding DOCSIS 3.1 Cable Modem Transmit Power - Broadband...

   broadbandlibrary.com › cable-modem-transmit-power

   • Αποθηκευμένο αντίγραφο

   Based on the estimated plant loss and known CMTS input power, one can conclude that the DOCSIS 3.1 cable modem should be transmitting SC-QAM channels around 44.6 dBmV and the OFDMA channel around 35.4 dBmV.

3. www.manualslib.com › manual › 3358498VIAVI ONEEXPERT ONX CATV USER MANUAL Pdf Download

   www.manualslib.com › manual › 3358498

   • Αποθηκευμένο αντίγραφο

   View and Download Viavi OneExpert ONX CATV user manual online. OneExpert ONX CATV test equipment pdf manual download. Also for: Onx-620, Onx-630 sweep.

4. community.virginmedia.com › t5 › Networking-and-WiFiPOWER LEVELS & SNR: A TECHNICAL PRIMER (updated October 2016)

   community.virginmedia.com › t5 › Networking-and-WiFi

   • Αποθηκευμένο αντίγραφο

   15 Απρ 2014 · For DOCSIS 3, power levels > 8 dBmv have been known to cause synchronisation issues. On the other hand, power levels up to 10 dBmv are known not to have cause problems although such levels are infrequent because the installation technician usually takes care of this aspect.

5. kb.netgear.com › 24311How do I view the downstream and upstream power levels of my...

   kb.netgear.com › 24311

   • Αποθηκευμένο αντίγραφο

   6 Δεκ 2016 · Downstream and upstream power levels are important when determining if the cable line that is connected to your cable modem or modem router is receiving sufficient power. Good Downstream power levels are within -7 to +7 dBmV. Good Upstream power levels are within 38-48 dBmV.

6. wolfpaulus.com › cable-modem-signal-levels-revisitedCable Modem Signal Levels revisited - Wolf Paulus' Journal

   wolfpaulus.com › cable-modem-signal-levels-revisited

   • Αποθηκευμένο αντίγραφο

   Ideal levels are approximately 40 to 50 dBmV for single channels, 37 to 48 dBmV each for 2 to 4 channels. The Signal to Noise Ratios should also all be within three dB of each other. However, for power level -15 to -6 dBmV the SNR should be 33 dB or higher and for -6 to +15 dBmV the SNR should be 30 dB or higher.

7. www.techreviewer.com › tech-setup › ultimate-cable-internet-wiring-guideUltimate Cable Internet Wiring & Optimization Guide (2024) -...

   www.techreviewer.com › tech-setup › ultimate-cable-internet-wiring-guide

   • Αποθηκευμένο αντίγραφο

   2 Οκτ 2024 · Signal Strength, or Power Level, is the amount of power sent or received by the modem in units of dBmV. The dBmV unit type represents a voltage relative to a reference voltage of 0 dBmV.