Αποτελέσματα Αναζήτησης
*AN UPDATED VIDEO HAS BEEN UPLOADED* A question I get most asked is "how do I apply gelcoat" while the answer is never a quick or short one, I decided to mak...
18 Αυγ 2009 · Apply catalyzed gel paste to the damaged area, working in into the area with a spatula or plastic spreader. Squeeze off the excess material. For greater smoothness and higher gloss, this repair should be covered with a piece of the enclosed clear plastic release film and left to cure.
27 Δεκ 2022 · This training module will review the differences between waxed (One-Step Gel Coat) versus un-waxed gel coats (Premium Gel Coats), differences between neutral gel coats and white gel coats from EVERCOAT, how to apply PVA Mol Release, when to be able to use acetate films and tips for mixing and color matching gel coats using the Evercoat Coloring ...
20 Νοε 2006 · This can be done either by adding a wax in the mix or by overspraying the applied gelcoat with polyvinyl alcohol. If applying multiple coats, you only do this on the topcoat. When laminating you leave the wax out until the topcoat.
Our Gel Coats can be tinted with Evercoat® Coloring Agents at a maximum of 1 oz. per quart of gel coat. Adding color to white gel coat will produce a pastel color and adding color to a neutral gel coat will produce a bold color.
deep scratches in fiberglass gel coat. One Step Finish Premium Gel-Kote™ is a non-run, non-sag formulation of flexible polyester resins to produce a resilient and durable finish. EVERCOAT Coloring Agents may be used to tint the material to the desired pastel color. GEL-KOTE SHOULD NOT BE APPLIED OVER AN EPOXY. APPROVED SUBSTRATES: Fiberglass
APPLICATION: • Apply catalyzed material to a thickness of 20 mils, or slightly above the surrounding gel coat. • Apply enough to slightly overfill to allow for finish sanding. • Allow approximately 30 minutes to gel and apply EVERCOAT PVA Mold Release, or apply a physical barrier such as acetate or wax paper during cure.
