Αποτελέσματα Αναζήτησης
*AN UPDATED VIDEO HAS BEEN UPLOADED* A question I get most asked is "how do I apply gelcoat" while the answer is never a quick or short one, I decided to mak...
11 Ιουλ 2007 · Clean the gelcoat surface with lacquer thinner, sand it lightly to give the surface some “tooth” and bond your block to the gelcoat with epoxy thickened with silica, microballoons or chopped fiberglass, clamped lightly. Prep your plastic block the same way. MintJulep July 11, 2007, 11:47pm #5.
16 Ιουν 2024 · For smaller repairs the gelcoat can be brushed on, but larger repairs, most manufacturers recommend application by spray gun. If working on a Kevlar hull be very careful when sanding not to sand into the fabric.
18 Αυγ 2009 · Gel coat is best applied by spray application with a pressure pot or catalyst injection system. Gel coat also can be applied with a standard paint gun with primer nozzle (70-80 thousandths) at 40-50 psi or Preval sprayer. Make sure that the catalyzed gelcoat does not set up inside the sprayer.
15 Μαρ 2020 · Fill a deep scratch with gelcoat, wait until it gels, and fill it again until the scratch is completely filled. Only then use a topcoat; If the damage is superficial, you can repair it immediately with Topcoat and a soft spatula; After the refill, the adhesive tape is removed, and the area is sanded; A fine grain size of 220 should be selected
18 Αυγ 2009 · Four drops of hardener in 1 teaspoon of gel paste will give approximately 15 minutes of working time before the material begins to gel. Mix the liquid hardener thoroughly into the gel paste. Apply catalyzed gel paste to the damaged area, working in into the area with a spatula or plastic spreader.
Did you know Evercoat Adhesives are the complete solution for replacing panels? Evercoat Bonding Adhesives eliminate the need for self-etch or epoxy primer and can be applied over properly sanded bare metal.
