Αποτελέσματα Αναζήτησης
display shows E9 error code, also LED on ODU PCB blinks. 2. Auto Mode (FEEL) (1) When the Auto mode is selected, the operation mode and initial temperature set are determined by the initial room temperature at start- up of operation except turn the air conditioner off and operate it again.
- Inverter air conditioner Service Manual
1). TIMER ON can be set only when the air conditioner is...
- Inverter air conditioner Service Manual
Check that air cannot enter the refrigerant system and check for refrigerant leaks when moving the air con ditioner. Carry out a test cycle after installing the air conditioner and record the operating data. he ratings of the fuse installed in the built incontrol unit are T 5A / 250V .
Important Notice This service manual is intended for use by individuals possessing adequate backgrounds of electrical, electronic and mechanical experience. Any attempt to repair the appliance may result in personal injury and property damage. Air Conditioner Service Manual 2.
Page 43 Air Conditioner Service Manual 1 .5 Examples of repairing 1 .5.1Display E1 or E2 Reasons: 1) The sensor connection terminal loose or not plugged in. Solution: Check the connecter of sensor and slot (CN6), if loose or not plugged in, please connect again.
1). TIMER ON can be set only when the air conditioner is OFF. 2). Press TIMER on the remote control ONCE to enter time setting. 3). Press “ ” or “ ” to set the time for unit to start working. 4). Set other function as MODE, FAN SPEED, SWING etc. 5). Press TIMER ONCE AGAIN to confirm the TIME ON setting TIMER OFF 1). TIMER OFF can be set ...
View and Download Everwell MRTH user and installation manual online. MRTH air conditioner pdf manual download. Also for: Mrth1823e, Mrth1823c, Mrth1223e, Mrth1223c, Mrth1213e, Mrth1213c, Mrth2423e, Mrth2423c.
Manually turn on the air conditioner. Find the air conditioning brand in the code table. Press the "Set" key for 3 seconds, release it when the LCD flashes and press "+" and "-" until you find the code on the screen and the LCD is flashing. Press the "Enter" key. The code will stop flashing. Verify that the remote control keys are effective.
