Αποτελέσματα Αναζήτησης
25 Νοε 2016 · The 56-50 Spencer (Taylor's) was built to C.I.P. specifications for operation in the Taylor Arms 56-50 Spencer. Rim diameter is .629" to .632", which may be too small to eject properly in some originals.
27 Δεκ 2011 · Armi-Sport 56-50 Dimensions (NOT the original 56-50 Spencer): Base diameter 0.56 in; Rim diameter 0.63 in; Case length 1.1 in; Overall length 1.5 – 1.70 in (1.57 in works best for me.)
CASES: At this point I see no need to use anything other than Starline 56-50 Spencer cases. They are readily available and reasonably priced (but not cheap). Cases can be made from 348 Winchester brass or 50-70 Gov't brass with modified rims.
The 56-50 Spencer (Taylor’s) was built to C.I.P. specifications for operation in the Taylor Arms 56-50 Spencer. Rim diameter of 0.629" to 0.632", which may be too small to eject properly in some originals. Rim thickness is 0.057" to 0.061". Thickness of wall at mouth is .0125" average.
19 Φεβ 2023 · Both RCBS and Lyman make 56-50 dies. The RCBS dies are what you want for the Taylor's 56-50 cartridge. The Lyman Dies are made from cut down 50-70 Govt. dies and will not properly crimp the brass unless you are using bullets over .515 in diameter.
Starline Brass is the only company offering cases for the .56-50 Spencer. RCBS dies were used to develop.56-50 Spencer loads. There are challenges associated with developing handloads for this cartridge. Foremost is the large caliber and case capacity, combined with relatively low pressures.
4 Φεβ 2012 · Case length 1.15 in. Overall length 1.5 – 1.70 in (1.57 in works best for me.) Cut the 32 gauge brass to length. I use the same case length as the Starline brass, which by my measure is 1.1 in. There are a number of ways to cut this brass. Some use the small cut off saw from Harbor Freight.
