Αποτελέσματα Αναζήτησης
Rancho has installation instructions available for many parts. However, for shocks and stabilizers, please refer to the vehicle's manual to get the proper torque specs. Please enter the part number you wish to look up.
Upgrading from the twin tube design. The monotubes provide much more controlled resistance. The previous models RS5405 are based on the twin tube RS5000 shoc...
Park the vehicle on a level surface and set the parking brake. Place the front wheels in a straightforward position by centering the steering wheel. If applicable, remove the nuts and U-bolts holding the stabilizer bracket to the tie rod end (illustration 1).
12 Ιουλ 2008 · HOW TO - Install Rancho Steering Stabilizers for '00-'01 X. 2) Park your X on a level ground and chock it to be on safe side. Loosen the 2 steering bolts in the back of the steering unit and replace the units factory bolts with the new bolts provided in the kit. Here is a pic of the old bolts:
Place the front wheels in a straightforward position. Loosen the nuts on the drag link adjusting sleeve clamps. Remove the bolt on the adjusting sleeve bracket. See illustration 1. Without moving the adjusting sleeve, turn the clamps until the bolts are vertical and on the front.
rancho dual steering stabilizer kit rs98510 — This kit will work only on vehicles with at least a 2” lift and 2" tall front bump stop spacers (not included).— READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION
INSTALLATION INSTRUCTION. 88058. Rev C. RS98510 Dual Steering Stabilizer and Bracket Kit . Includes two Rancho RS5405 Steering Stabilizers. Fits: 2005 and Later Ford Super Duty F250 and F350. This kit will work only on vehicles with at least a 2” lift and 2" tall front bump stop spacers (not included).
