Αποτελέσματα Αναζήτησης
If a new cylinder head has been installed then the special tool 303-1449-02 without the thread must be used to install the supercharger. If a new cylinder head has been installed, then new taptite bolts must be used to install the supercharger.
29 Δεκ 2020 · There are many reasons you might want to remove the supercharger in your Jaguar F-Type. Like me, you may have suffered a coolant pipe failure under the supercharger (a design fault), or you might need to replace the supercharger coupler.
NOTE: This Harrop FDFI TVS2300 Supercharger kit is designed for the 5.0 Supercharged AJV8 fitted to JAGUAR and RANGE ROVER . with electronic bypass actuator sensor , as a factory replacement. Refer manufacturers procedure for removal of the OEM Supercharger from the vehicle.
10 Αυγ 2008 · Hi, The drive coupler of my (XKR 2001) supercharger (Eaton M112 with specific casing) is making some rattling at idle; time to change it. I found the right oil (see other post), and the coupler on Ebay, but now I….
9 Φεβ 2020 · Renew the coolant expansion tank/reservoir as well and the hose/pipe that runs from it. Consider an SC rebuild kit (coupler, bearings and oil) not just coupler and oil, plenty of kits on Fleabay. As well as the coolant pump renew the thermostat.
21 Σεπ 2018 · After a lovely 2 week 2200 mile tour of Germany and Austria, I now need to change the supercharger coupler. It has got a lot noisier since the trip. The noise in the clip is when the engine is cold, it is much quieter when warm and the car drives perfectly with no warnings.
26 Μαρ 2021 · From the top of the supercharger assembly to the top of the heads is at least 15 cm, which is about 5.9 inch. You'll probably need a bit more, considering heat and vibrations and all. I've attached another picture regarding the depth, but this depends on your setup.
