Αποτελέσματα Αναζήτησης
The Lynx module can be opened up by unscrewing the 2 cover screws. The contacts on the left side are covered by a removable rubber sleeve. Red is the positive and black is the negative busbar.
The connector of the Lynx Smart BMS 500A has 11 pins, numbered from left to right starting with pin 1 and ending with pin 11, while the connector of the Lynx Smart BMS 1000A has 13 pins - two additional pins (pin 12 and 13) for future functionality.
A system schematic shows schematically how Victron Energy devices are connected to each other. Find schematics for your product.
If the Lynx Distributor is used without a Lynx Shunt VE.Can or a Lynx Smart BMS, it needs to be powered in an alternative way so that the fuse detection circuit is operational. To power the RJ10 cable for standalone use, do the following: Connect pin 1 of the RJ10 connector to 5V (4.5V-5.5V). Connect pin 4 to GND.
Every individual 24V/180Ah Lithium-Ion battery has an onboard Battery Management System, which monitors and protects the battery on cell level. The Lynx Ion + Shunt communicates with all battery packs via the BMS CAN-Bus and monitors the system as a whole.
The lynx system is a modular DC bus bar system used to connect batteries, DC equipment and provide fusing and battery monitoring. It consists of the following modules:
The Lynx has 3 flex settings, with the Slic Pin locating the Pivot Strap at one of three locations. The furthest forward position (#1) will give you a more neutral flex, while the rear position (#3) will give you a slightly stiffer, more active flex. To move a Slic Pin, use a small tool or fingernail to press the wedge
