Αποτελέσματα Αναζήτησης
The Lynx Smart BMS integrates seamlessly into our Lynx Distributor system and is available as a 500A (with M8 busbar) or 1000A (with M10 busbar) version. Page 1 Introduction
The connector of the Lynx Smart BMS 500A has 11 pins, numbered from left to right starting with pin 1 and ending with pin 11, while the connector of the Lynx Smart BMS 1000A has 13 pins - two additional pins (pin 12 and 13) for future functionality.
The internal wiring diagram of the Lynx Distributor. 3.2. Fuse detection. The Lynx Distributor monitors each fuse and will detect a blown fuse. When a fuse blows, the red fuse LED will illuminate, the power LED will turn red and an alarm message is send to a connected Lynx Smart BMS.
21 Μαρ 2018 · This approach is often referred as a 3LD model (Three lines of defense). 3LD models distinguish several business functions between “risk owner” and “risk manager” (the functions that deal with risk), also between “overseeing risks” and the “independent assurance”.
All cables and wires connected to the Lynx module need to have been fitted with M8 cable lugs. Pay attention to the correct placement of the cable lug, washer, spring washer and nut on each bolt when attaching the cable to the bolt. Tighten the nuts using a torque of: M8 Model: 14Nm.
Every individual 24V/180Ah Lithium-Ion battery has an onboard Battery Management System, which monitors and protects the battery on cell level. The Lynx Ion + Shunt communicates with all battery packs via the BMS CAN-Bus and monitors the system as a whole.
Lynx Smart Hub is a new type of field controller that adds security, programmability and sensing to the benefits and simplicity of a two-wire system. The system can be segmented into manageable areas for simplified maintenance
