Αποτελέσματα Αναζήτησης
27 Οκτ 2013 · I have removed the barrel from my Model 60 and successfully reinstalled it but I don't recommend it. As others have said, there is no need to do so. I was stripping the gun down to sell for parts then I had a change of heart and reasembled it. The hardest part is getting it properly aligned.
5 Μαρ 2007 · I'm thinking of cutting my barrel down a couple of inches and would like to know what's involved in removing the barrel from a mod 60. I see the pin through the receiver and barrel and a pin through the magazine tube band. Are these the only things to remove to get the barrel out?
27 Οκτ 2013 · With the receiver now rigidly held down I have removed the band and milled a nice wide groove for the barrel to sit in. I realise this is the Marlin site, but I'm most impressed with this Ruger, it's been well thought out and working on it has been straight forward.
14 Απρ 2013 · It is very easy to remove the barrel. Strip the receiver, remove the pin holding the barrel. Hold the barrel in on hand and with a rubber mallet tap the receiver and the two will separate. Replacing is easy too, must make sure you line it up straight so the pin hole lines up.
Start to finish, this is how to take apart your Marlin Model 60. Step by step instruction with no guess work. Replace any parts or springs. Tools and cleaning supplies linked below.
14 Φεβ 2005 · The Firing Line Forums > The Skunkworks > The Smithy: marlin model 60 barrel replacement
4 Φεβ 2021 · To remove the barrel, there is a cross pin at the front of the receiver that has to be driven out, then the barrel can be extracted from the receiver. The barrel might be fairly tight in the receiver, and take some persuasion to get apart. The second issue is finding a replacement barrel.
