Αποτελέσματα Αναζήτησης
11 Σεπ 2011 · The receiver is drilled to use any and all mounts that will fit the Marlin big bore lever action rifles, 1895,.444, 336. You can find mounts from all major makers easily online. Bob B.
4 Ιαν 2011 · I've not been successful finding an old 10/22 to use as a basis for a build so I've been looking at custom receivers. I like the looks of the NDS-22. Has anyone used one? How did everything fit?
24 Μαρ 2006 · Theirs is a really nice, well made, well finished receiver. Also worthy of note that it takes Marlin 1894 mounts that use heavier 8-40 screws and their proprietary rear sight is excellent. It's a much better receiver than the factory Ruger and affordable to boot.
The National Design Specification® for Wood Construction (NDS®) was first issued by the Na-tional Lumber Manufacturers Association (now the American Wood Council) (AWC) in 1944, under the title National Design Specification for Stress-Grade Lumber and Its Fastenings. By 1971, the scope of the Specification had broadened to include additional
i-. cable to structural end-jointed or edge-glued lumber of. the same species and grade. Such use shall include, but. not be limited to light framing, studs, joists, planks, and. decking. When finger jointed lumber is marked “STUD. USE ONLY” or “VERTICAL USE ONLY” such lu. m-.
The Nodak Spud NDS-22 aftermarket receiver for the Ruger 10/22 is one great way to immediately improve your 10/22. Highly regarded, the Nodak Spud receiver is CNC machined from a solid billet of 6061/6T aircraft grade aluminum. This is a stripped receiver and in-the-white.
Size (when closed) 148.7 mm wide / 84.7 mm deep / 28.9 mm high. Weight: 275 g. Upper screen. Back lit, 7.62 cm diagonal, half transparent TFT LCD screen with a resolution of 256 x 192 pixels and 0...
