Αποτελέσματα Αναζήτησης
11 Σεπ 2011 · They are precisely made, tough as nails anodizing, and Mike and Harlan are nice people to deal with. 10-22 mounts will not work. The receiver is drilled to use any and all mounts that will fit the Marlin big bore lever action rifles, 1895,.444, 336.
4 Ιαν 2011 · I've not been successful finding an old 10/22 to use as a basis for a build so I've been looking at custom receivers. I like the looks of the NDS-22. Has anyone used one?
i-. cable to structural end-jointed or edge-glued lumber of. the same species and grade. Such use shall include, but. not be limited to light framing, studs, joists, planks, and. decking. When finger jointed lumber is marked “STUD. USE ONLY” or “VERTICAL USE ONLY” such lu. m-.
Solutions have It is intended that this document be used in conjunction been developed based on the 2015 and 2018 National with competent engineering design, accurate fabrication, Design Specification® (NDS®) for Wood Construction, and adequate supervision of construction.
to particular wood products or connections are given in. other Chapters of this Specification. 3.1.2 Net Section Area. 3.1.2.1 The net section area is obtained by deduc. t-. ing from the gross section area the projected area of all. material removed by boring, grooving, dapping, notch-.
24 Μαρ 2006 · Theirs is a really nice, well made, well finished receiver. Also worthy of note that it takes Marlin 1894 mounts that use heavier 8-40 screws and their proprietary rear sight is excellent. It's a much better receiver than the factory Ruger and affordable to boot.
Size (when closed) 148.7 mm wide / 84.7 mm deep / 28.9 mm high. Weight: 275 g. Upper screen. Back lit, 7.62 cm diagonal, half transparent TFT LCD screen with a resolution of 256 x 192 pixels and...
