Αποτελέσματα Αναζήτησης
User Guide for Pre-Delivery Inspection (PDI) and Service. Interactive Electrical Wiring Diagrams (iEWD) - Components, Connectors, Wire Properties. Electrical Reference Library (ERL) - Connector, Location, Pinout, Wires. TOPIx Cloud Diagnostics - Download and Installation.
The increased pressure forces the diaphragm downward, thus closing the valve. All valves have a range of pressure and water flow that must be maintained in order to work properly.
The first step is to visually check the control valve and all its accessories. Check for any air leakage or physical damage. If found any issues then correct them. Check the air supply from the air filter regulator (AFR) to the valve positioner or solenoid valve whichever is applicable.
Information - Diagnosis and Testing (see TOPIx Workshop Manual, section 412-00). NOTE: the Direct Pressure Sensing (DPS) valve may also be referred to the Electronic Control Valve. Replace the A/C compressor Direct Pressure Sensing (DPS) valve replacement procedure.
pressure by opening a service valve, which will vent all pressure into the atmosphere: remove all electrical power. NOTE If the vehicle’s ECM/TCM are replaced or re-programmed, ensure the compressor programming is retained or reset in the vehicle’s ECM/TCM to Vanair ® specifications. For assistance, contact the Vanair Service Department. NOTE
DIAGNOSTIC PROCEDURE: 1. Remove the accessory drive belt (see TOPIx Workshop Manual section 303-05: Accessory Drive - INGENIUM I4 2.0L Diesel - Removal and Installation - Accessory Drive Belt)
Troubleshooting . Installation / Start-up. NOTE: Flushing of all pipe lines is to be performed to remove all debris prior to installing valve.
