Αποτελέσματα Αναζήτησης
Test Equipment PULSAR Operating Manual Instructional Material. Description of Relay. The CVE is a synchro-verifier relay and the CVE-1 is a synchro-verifier relay with line and bus voltage sensing relays. The synchro-verifier is used to verify the condition of synchronism existing between two system voltages.
PULSAR is designed to test virtually any relay, from simple overcurrent relays to complex three-phase, microprocessor-based relays requiring phase-shifting capability. This table lists relays by IEEE device number and matches them with the required combination of current and voltage amplifier modules. Base unit includes Input Power and Control ...
PULSAR is designed to test virtually any relay, from simple overcurrent relays to complex three-phase, microprocessor-based relays requiring phase-shifting capability. This table lists relays by IEEE device number and matches them with the required combination of current and voltage amplifier modules.
View and Download Pulsar Ultra 4 instruction manual online. Ultra 4 measuring instruments pdf manual download.
PULSAR takes relay testing to the ultimate level with actual reproduction of faults, including dc offset and harmonics. Transient waveforms can be produced by PULSAR in several ways: mathematically using Fourier
Page 139 PULSAR MEASUREMENT P996 Relay Test Press a numeric key corresponding to the number of the relay you wish to test, and the relay will change state each time the key is pressed. If you press any other key, other than a valid relay number, then the test will end.
PULSAR is designed to test virtually any relay, from simple overcurrent relays to complex three-phase, microprocessor-based relays requiring phase-shifting capability. This table lists relays by IEEE device number and matches them with the required combination of current and voltage amplifier modules.
