Αποτελέσματα Αναζήτησης
12 Ιαν 2021 · Then double clicked the slic3r.exe file, and get this error: The code execution cannot proceed because perl524.dll was not found. Reinstalling the program may fix this problem.
Slic3r will attempt to fix any problems it can, but some problems are out of its reach. If the application complains that a model cannot be sliced correctly then there are several options available, and the ones described here are all free at the time of writing. Netfabb Studio.
21 Απρ 2017 · Slic3r crashes while opening the attached stl file. console output is as follows: (the messages up to but not including the assertion error are printed while opening other files, too, so maybe irrelevant) 16:55:13: Warning: Mismatch between the program and library build versions detected.
20 Ιουλ 2019 · The first time i opened slic3r all was ok until i tried to slice a amf-file. Then slic3r crashed and since then it is not possible to start slic3r anymore. The only thing which won't crash is slicing from the CLI. I'm using the AUR binary, which downloads it directly from the GitHub releases page.
Undulations in the walls of a print may be due to wobble in the Z axis. A thorough analysis of the potential causes is given by whosawhatsis 1 in his article "Taxonomy of Z axis artifacts in extrusion-based 3d printing" 2, however one point of particular interest for users of Slic3r is the wobble caused by motor steps not matching the pitch of ...
Slic3r has two features to aid newcomers: the configuration wizard, and simple mode. Sometimes it is nice to have a helping hand when starting out with new software. The configuration wizard asks a series of questions and creates a configuration for Slic3r to start with.
Like when printing small parts that loose form while you print? Any of that usually comes down to the often confusing settings in Slic3r, so I will try to show you where you have to be careful, what settings cause problems and so on. Step 1: Calibration.
