Αποτελέσματα Αναζήτησης
Should the Model 18 Monitor fail to operate properly, check that all three voltages are present, and are of the correct voltage level and phase rotation (a Model 188 Phase Sequence Detector should be used to verify phase rotation). Check all fuses and verify that all wiring connections are correct. If problems persist, contact your local Time Mark
11 Νοε 2019 · The phase failure relay circuit diagram is made up of three components: a voltage detector, a time delay, and an output relay. The voltage detector is used to detect any difference in the voltage between two of the three power supply lines in the system.
10 Ιουλ 2016 · In the above diagram, I have shown the complete method of wiring or connection of phase failure relay diagram with circuit breaker, cont actor, overload relay, push-button switches, and electric motor, however, let’s talk about this step by step.
Phase failure detection If all phases (and the neutral) are present, the output relay energizes after the start-up delay t s is complete. If a phase failure occurs, the tripping delay t v starts. When timing is complete, the output relay de-energizes. As soon as the voltage returns to the tolerance range, timing of t s starts.
• Single phase connection possible • De-energized on trip • LED indicator for each phase and state of output contacts • Output 1 changeover contact • Width 35 mm Monitoring of 3 phase voltage systems for phase failure. On phase loss the output relay is de-energized after an adjustable time delay (contact 15-18 closed) 0245238 M8388 L2 ...
This device consists of a solid-state voltage and phase-angle sensing circuit, driving an electromechanical relay. When correct voltage and phase rotation are applied, the internal relay will energize. A fault condition will de-energize the relay. When the fault is corrected, the monitor will automatically reset (a manual reset version is also
The Connection Diagram below shows a typical installation, whereby the supply to a load is being monitored by the Phase monitoring relay. If a fault should occur (i.e. fuse blowing), the relay will de-energise and assuming control of the external Contactor, de-energise the Contactor as well.
