Αποτελέσματα Αναζήτησης
NOTE: If fascia run is over 9 metres then place markings at 9 metre spacings. This is done using the 'Square Level'. Push the level to the stop screw, watching the bubble glass for level and then mark vertical line. The horizontal mark would be marked on the square from step 1, so mark horizontal mark to the rafter. Horizontal mark on 'square ...
Pancake screws are applied to the “nail strip” of the standing seam panels. When used, extended drip edge should be installed first along the drip edge of the roof. The lower end of each panel is then trimmed and the hem pre-bent before installation (see pg 9).
FASCIA WITH FORM AND FUNCTION. Fascia is used as a base to attach the gutters to, or as a cover to hide the fixing space between the roof, eaves and wall. More than just functional, Stratco Fascia is designed to form a neat, attractive edge between the roofing and wall surface.
Screw Functions • Positional screw – screw has a neutral effect on fracture fragment position, pilot hole diameter is slightly greater than screw core diameter • Plate screw – can be locking or non-locking head; non-locking produces friction between plate and bone due to compression; locking provides angular stability •
To determine the number of 16” soffit panels required, follow these simple steps: Measure width of soffit from wall to outside of fascia board. Measure length of overhang. Use chart to find the number of panels needed.
3.5 Identification of screws 12 3.6 Setting of screws 13 3.7 Quantity of fasteners and clips 14 3.8 Recommended fasteners and locations 14 4.0 CURVED, BENT & TAPERED CLADDING 19 ... 6.2 Design of drainage (eaves-gutter system) 27 PART B: INSTALLATION 7.0 GENERAL CARE, SAFETY AND HANDLING 30 7.1 Safety 30 7.2 Care and storage before installation 30
Fascia & Soffit Systems Installation Guide. Soffit installation: Step 1: Each soffit or fascia panel’s protective film is printed with directional arrows. Ensure panels are fixed with the arrows pointing in the same direction to ensure a uniform surface appearance.
