Αποτελέσματα Αναζήτησης
25 Φεβ 2016 · Initially there was no input and when I started tweaking and reinstalling stuff I finally got a signal, a super low signal with a HUGE feedback sound (i had to use the asio4all driver to get the signal). From what I can tell , I can't select the ux1 as an input in my recording devices.
10 Φεβ 2021 · POD Studio UX1 Manuals. Create, record and perform with guitar in new ways.
Input 1 (Instrument) – Connect your guitar or bass here using a standard 1/4-inch TS instrument cable. POD X3 itself contains the processing power that turns your naked input signal into that roaring guitar Tone, which is then fed to the “Direct/Studio Mix” and out the Analog Left & Right Outputs and S/PDIF digital output.
6 Απρ 2020 · The UX1’s driver settings panel allows you to easily switch which inputs you want to send to your DAW (eg: instrument, mic, both, etc) and it’s very easy to send both an instrument and microphone signal to two different tracks at the same time without any issues.
I investigated by going into my sound settings panel, where it said that the device was ready for recording but didn't show any input, and clicked around trying to find the source of the problem.
As an interface, the UX1 normally operates at 24-bit, 44.1kHz or 48kHz. It works fine as the sole interface in a computer setup, providing you only need two inputs and two outputs, and the output level control is ideally placed for setting the level of connected active monitors or headphones.
22 Δεκ 2015 · I have been searching the web to find out if my line 6 UX1 will work with Windows 10 and allow me to record with Audacity. Could not find a definitive answer. On the line 6 forums there are folks reporting that the updated drivers (v4.2.7.6) to enable UX1 to work with Win 10 don't work.
