Αποτελέσματα Αναζήτησης
The 2AR-FE engine is an in-line, 4-cylinder, 2.5-liter, 16-valve DOHC engine. This engine uses the Dual VVT-i (Variable Valve Timing-intelligent) system, DIS (Direct Ignition System), ACIS (Acoustic Control Induction System) and ETCS-i (Electronic Throttle Control System-intelligent).
7 Σεπ 2011 · Last Modified: 9-7-2011 6.4 K From: 201008 Model Year: 2011 Model: RAV4 Doc ID: RM000003PXP00DX Title: 2AR-FE ENGINE MECHANICAL: ENGINE UNIT: COMPONENTS (2011 RAV4)
Toyota 2AR-FE 2.5L Engine Specs, Problems & Reliability. The 2AR-FE was released in 2008. It came to replace the 2.4-liter 2AZ engine. The engine consumes less fuel than the predecessor, but the output is on the same level.
The 2.5-liter Toyota 2AR-FE engine has been assembled since 2008 at factories in Japan and the United States. The motor is installed on a wide range of front-wheel drive models of the concern, including Lexus and Scion.
Do not start the engine for at least 4 hours after the installation.-After the installation, if the seal packing has seeped out, wipe it off. 5. INSTALL VALVE STEM CAP (a) Apply a light coat of engine oil to the valve stem ends. (b) Install the 16 valve stem caps to the cylinder head.
Toyota 2AR-FE specs: Rated power, bore and stroke, fuel system, cylinder block, cylinder head and valves, piston and piston rings.
4 Μαρ 2013 · I was looking for cooling system diagram for 2AR-FE. The document shows it. But there are many different components, like fittings, tubes, specifically around the transmission heater.
