Αποτελέσματα Αναζήτησης
30 Απρ 2020 · On the bottom of the square tool block there is a little hole should have a stiff spring and a ball bearing in it, this will locate in the 4 shallow holes drilled into the round base. It will set the tool post back in the same spot after being rotated around to use other tools.
- Four Way Tool Post
On the machines at the hydraulic shop, the 4 way post gets...
- Four Way Tool Post
9 Νοε 2012 · On the machines at the hydraulic shop, the 4 way post gets into the tailstock center unless you have the tool way out. Could keep it a lot closer in with a QC, for added rigidity and/or not have to work off the open end of the steady.
4 detents, at every 90 degrees, to easily find location quickly. 40 total angular location points, every 9 degrees for ‘off-90’ tool locations. Quick camlock action locks toolholders securely and accurately with great ease; quickly exchange pre-set tool holders for near turret disk efficiency.
15 Αυγ 2016 · A short demo of the Parat 4-way-indexing-quick-change turret-toolpost. For more information regarding purchasing, installing or maintenance of this system visit...
21 Ιαν 2010 · You will need a spigot on the base plate made a snug but rotating fit in the larger bore at the bottom of the tool post to ensure reliable repositioning. Use the tapped holes in the Tee nut to clamp the plate and Tee nut in place on the top slide. The tool post should be a very loose fit on the stud.
Advantages of using the PARAT 4-way Turret. High reproducible accuracy of 0.005 mm when turning out and back in. No additional finishing cuts with fits. Less opening of the sliding guard. Fewer exchanges of the tool holder. Fast and simple exchange through eccentric clamping.
22 Δεκ 2009 · The inexpensive 4 way tool posts just have 4 slots cut into the bottom of them with the indexing pin coming up out of the top of the compound. They work, but not as well as the 12 position ones. There is a 4 way tool post that has only 4 positions that was used on turret lathes.
