Yahoo Αναζήτηση Διαδυκτίου

Αποτελέσματα Αναζήτησης

  1. Use Prevailing Torque All-Metal Nut chart if using this style of nut. = Nominal Diameter. = Clamp Load For J429 Grade 5 and 8, FNL Grade 9, A574, Class 4.6, 8.8, 10.9 and 12.9, the clamp loads are listed at 75% of the proof loads specified by the standard. For A307 Grade A, 75% of 36,000 PSI is utilized.

  2. Torque Table. The following suggested tightening torques provide an excellent starting point for determining torque requirements. Remember, you may need to vary these numbers somewhat based on the individual joint or the amount of fastener lubrication.

  3. Torque specifications, especially for critical joints, should be determined under actual assembly conditions due to the many variables involved which are difficult to predict and do affect the torque-tension relationship. The above recommended clamp loads are based on 75% of the minimum specified proof loads for each grade and size. Proof. Tensile.

  4. Due to many variables that affect the torque-tension relationship like human error, surface texture, and lubrication the only way to determine the correct torque is through experimentation under actual joint and assembly conditions.

  5. The torque values can only be achieved if nut (or tapped hole) has a proof load greater than or equal to the bolt's minimum ultimate tensile strength. Clamp load calculated as 75% of the proof load when specified by the standard. ASTM A307 utilized 75% of 36,000 PSI. Torque values for 1/4 and 5/16-in series are in inch-pounds.

  6. Torque Table. The following suggested tightening torques provide an excellent starting point for determining torque requirements. Remember, you may need to vary these numbers somewhat based on the individual joint or the amount of fastener lubrication.

  7. ASTM A193/A193M B8 and B8M Class 1 Torque-Tension Guide. Caution: Stainless steel fasteners tend to gall, especially with long run downs, prevailing torque fasteners, impact drivers, and lack of lubrication. It is highly encouraged to use a lubricant such as graphite-based anti-seize or molybdenum disulfide based anti-seize or other ...

  1. Γίνεται επίσης αναζήτηση για