Αποτελέσματα Αναζήτησης
Use Prevailing Torque All-Metal Nut chart if using this style of nut. = Nominal Diameter. = Clamp Load For J429 Grade 5 and 8, FNL Grade 9, A574, Class 4.6, 8.8, 10.9 and 12.9, the clamp loads are listed at 75% of the proof loads specified by the standard. For A307 Grade A, 75% of 36,000 PSI is utilized.
Torque Chart for Stainless Steel Cap Screws. Imperial has made a concerted effort to provide accurate information in its catalog and on its web site, however Imperial assumes no responsibility for the accuracy of the information.
The torque values can only be achieved if nut (or tapped hole) has a proof load greater than or equal to the bolt's minimum ultimate tensile strength. Clamp load calculated as 75% of the proof load when specified by the standard. ASTM A307 utilized 75% of 36,000 PSI. Torque values for 1/4 and 5/16-in series are in inch-pounds.
FASTENER TORQUE CHARTS. GUIDE FOR PREVAILING-TORQUE LOCK NUT ASSEMBLY TORQUES (CAD AND WAX, GRADE B, C, AND GRADE G FLANGE NUTS) LOCK NUT STANDARDS FROM IFI-100 REQUIREMENTS. Torque-Tension Requirements. Clamp Loads for the Grade B lock nuts equal 75% of the bolt proof loads specified for SAE J-429 Grade 5, and ASTM A-449 bolts.
5/16-in diameter are in inch-pounds; diameters 3/8-in and larger are in foot-lbs. Torque values for metric fasteners up through and including M8 are in inch-pounds; diameters M10 and larger are in foot-lbs.
Use SAE 2, 5 or 8 values when grade is known, with a nut of sufficient strength. There is no difference in the above chart between the torque figures for fine or coarse threads. The torque figures
The following suggested tightening torques provide an excellent starting point for determining torque requirements. Remember, you may need to vary these numbers somewhat based on the individual joint or the amount of fastener lubrication. This table is offered as the suggested maximum torque values for threaded products and is only a guide.
