Αποτελέσματα Αναζήτησης
MOUNTING TEMPLATE. Cat. Nos. 0540, 0541, 0542, 0543, 0580, 0581, 0582, 0583, 0590 & 0591 Series Combination Gas/Vent Fills Installation and Operation Instructions. PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING. Select mounting location: In accordance with A.B.Y.C., U.S. Coast Guard and E.P.A. requirements and regulations.
Allow for adequate clearance under fill for routing fill and vent hose, which must be selected and installed in accordance with A.B.Y.C. requirements and U.S. Coast Guard Safety Standards for Small Boat Fuel Systems (33 CFR 183). FUEL VENT: DO NOT locate on a surface that can become substantially submerged or flooded, otherwise water can be drawn
2). Locate the mounting surface with a thickness up to 5/8 inch maximum. 3). Drill a 1-5/8 inch diameter hole in the mounting surface. 4). Make sure the vent head is tightened against the threaded end of the vent neck to insure proper seal. 5). Remove nut, washer and mounting flange. 6).
The Attwood Stainless Steel Fuel Vent fulfills a USCG fuel system requirement — it vents out fuel vapors that could cause dangerous tank pressure and vents in air to displace consumed fuel.
Eliminates the need to install a fuel line vent and a surge protector — now, one product helps avoid spills, provides fuel tank venting, and resists water instrusion into the fuel system.
The Lifeguard fuel / air separator is designed to be installed in--line in your existing fuel tank vent hose to prevent fuel spillage into the waterways. This saves you
Trident A2 Fuel Line Hose for gasoline vent and diesel feed or vent (including bio diesel blends up to 100%). The #317 series exceeds ABYC H-24 & H-33, SAE J1527, ISO 7840, & USCG Type A2; and is NMMA Type Accepted, CE certified and Lloyds Registry Type Approved.
