Αποτελέσματα Αναζήτησης
4. Attach and clamp 1-1/2 inch fill hose and 5/8 inch vent hose in accordance with the above referenced standards. 5. The vent system requires that the surge valve feels loose in order to operate properly. Remove two screws under cap to access flame arrestor screen for cleaning. NOTE: Plastic fuel fills should NOT be grounded. (1).
1).The Tank vent must be installed in accordance with U.S.C.G. Safety Standards for Boat Gasoline Fuel Systems, #33CFR183 and A.B.Y.C. Standard H-24. 2). Locate the mounting surface with a thickness up to 5/8 inch maximum. 3). Drill a 1-5/8 inch diameter hole in the mounting surface. 4).
Allow for adequate clearance under fill for routing fill and vent hose, which must be selected and installed in accordance with A.B.Y.C. requirements and U.S. Coast Guard Safety Standards for Small Boat Fuel Systems (33 CFR 183).
- Check length of vent hose from tank vent to thru-hull vent and trim as needed. - Slide open end of vent hose over the neck of the thru-hull vent. Make sure that the hose has not been compromised
Eliminates the need to install a fuel line vent and a surge protector — now, one product helps avoid spills, provides fuel tank venting, and resists water instrusion into the fuel system.
APPLICATION. Installs into hull exterior and provides a splash-resistant thru-hull vent exchange. For hull thickness from .100" or 2.5mm (aluminum hulls) to 7/8" or 22mm. Designed to work on traditional tank vent systems with standard 5/8" I.D. (16mm) fuel vent hose. REQUIRED FOR INSTALLATION. Pencil • Marine-quality silicone sealant.
Trident A2 Fuel Line Hose for gasoline vent and diesel feed or vent (including bio diesel blends up to 100%). The #317 series exceeds ABYC H-24 & H-33, SAE J1527, ISO 7840, & USCG Type A2; and is NMMA Type Accepted, CE certified and Lloyds Registry Type Approved.
