Αποτελέσματα Αναζήτησης
1967-1973 Mustang axles can be identified by wheel flange: Oval hole = 28 splines; Two large holes and counter-sunk center = 31 splines. Also of Interest: Axle Flange Housing Identification
Visually Spotting the 9" and 8" Axle Housings. Shown above is the typical 1967 and up 9" (lower) and pre-1967 8" housing (upper).Note no fill plug on back of the 67 and up housing, this is true for the 67 and up 8 inch housings too.
6 Δεκ 2010 · Add 5" to these figures and it will give you the overall width from wheel flange-to-wheel flange. The 8.8" rear end wasn't put in service in the Mustangs until 1986, when the Mustangs went to fuel injected 5.0L engines [NOT the same thing as a MODULAR engine].
8 Οκτ 2011 · The Ranger and Aerostar rears are the wrong width for a Mustang, and the pinion is off center as well. Lots of people have used the Explorer rear in 67-70s with no problem.
1967 Ford Mustang Axle Information & Ratios. The first table is the code and gear ratio. If you know your axle tag number, simply go to the second table. Axle code. Ratio & type.
Currie ® 9-inch Rear End Builder for 1967 thru 1970 Mustang and Cougar vehicles are offered with a broad range of options ranging from kit components to complete, highly optioned, ready-to-bolt-in assemblies. *** SELECT OPTIONS TO BUILD AND PRICE *** Select Build Type * Select Housing and Axle Kit * Select 3rd Member * Select Brake Package *
16 Δεκ 2002 · Just wondering if anyone knows off hand what the width is from flange to flange for the factory rear end in my 67 mustang. Thanx alot. Save Share
