Αποτελέσματα Αναζήτησης
Use a clean lubricated air supply that will give a measured air pressure at the tool of 6.2 bar (90 psig) when the tool is running with the lever fully depressed. It is recommended to use an approved 10 mm (3/8 in) x 8 m (25 ft) maximum length airline.
3 Ιουλ 2020 · OPERATOR’S MANUAL FOR AirVANTAGE™ 10,000 RPM 3 in. (77 mm) BUFFER Operator Instructions Includes – Please Read and Comply, Proper Use of Tool, Warranty, Product Configuration and Specifications Table, Parts Page, Parts List, Back-Up Pads, Work Stations, Putting the Tool Into Service, Operating Instructions and Compressor Layout.
1. You will find all O-rings, Supporter Rings, and Springs needed for rebuild of the Pulse Unit in a Pulse Unit Repair Kit (PRK). To order a PRK, you would order the model number of tool plus dash PRK (i.e., UAT-70-PRK). 2. Lubricate all O-rings with Pulstar Oil. 3.
Carefully read, understand and follow tool manuals before operating or servicing Dynabrade® Power Tools. Always operate, inspect and maintain tools in accordance with all safety codes and regulations for the protection of operating personnel as well as adjacent areas. All products offered by Dynabrade® are not to be modified, converted
supply lines, air line pressure, proper lubrication and repair of tools. Refer to ANSI B186.1 for additional maintenance information. • Use only genuine Dynabrade replacement parts to insure quality. To order replacement parts, specify Model#, Serial# and RPM of your air tool.
detailed information about the maintenance of your pneumatic tool can be found in the instruction manual. if you no longer have the manual in your possession then you can request either a printed or pdf-file version from us at any time.
1. Make sure the size of air supply lines conforms to tool’s maximum operating pressure at tool inlet. 2. Dry the drain from valves at low points of piping, air filter and compressor tank daily. 3. Make sure to only connect an air line made of components as shown in the following diagram. 4. Before daily use, add a few drops of air tool oil ...
