Αποτελέσματα Αναζήτησης
8 Φεβ 2017 · When the router comes up, you can access the admin page only for about one minute. In this period, you have to login the admin page, open the firewall tab, check the disabled radio button and save the new setting.
20 Αυγ 2013 · Use ipconfig or a similar command to find out your Gateway address, and use that IP to access your router's page. Make sure you're connected directly. Some routers can be configured to not allow administration over Wi-Fi, or any other link not directly connected to the router.
11 Ιαν 2023 · This article provides troubleshooting steps if you can’t access your router. The easiest way to manage your router’s settings and wireless network is the Nighthawk app. You can use the Nighthawk app to update your router’s firmware or check the speed of your network.
21 Μαρ 2024 · Restore the router to default settings, then try again to open the Settings page. There is a Reset Button on the back of the router. When the router is powered on, press and hold the Reset Button (approximately 5 secs) until the Power LED starts flashing, then release the Reset button.
29 Μαρ 2022 · So, here is the solution: Use paper clip to hold down the reset button for 10 seconds. Router Restarts. Use wired device to connect to router at 192.168.1.1. Wait. Go through the new setup process as all of your settings gone. Rebuild your router like you took it out of the box.
21 Μαρ 2022 · If you can access TP-Link login address correctly using the domain name or IP address, but fail to log in using login username and password. The default username and password are both admin in lower case.
8 Μαρ 2022 · This article provides advanced troubleshooting steps if you can’t access your router. To regain access to your NETGEAR router, try the following: Connect directly to your router with Ethernet. Using an Ethernet cable, connect your computer to one of your router’s LAN ports.
