Αποτελέσματα Αναζήτησης
A properly installed chimney flashing system is vital for protecting your home from costly water damage. Understanding the different types of flashing, as illustrated in the chimney flashing diagrams provided, and the importance of proper installation is crucial for maintaining a leak-free roof.
Flashing typically consists of (1) “step” flashing, which is attached to the roof, (2) “cap” flashing, which is attached to the chimney or a wall ( Figure 10-2 ), (3) “drip edge” flashing, and (4) “valley” flashing.
The use of flashing in chimneys presents some unique construction details. The three primary areas of concern are: the base of the chimney, the intersection of the chim-ney with the roof, and the chimney crown. The Base. The base of the chimney is constructed in much the same manner as a brick cavity wall.
chimney flashing details (steps 5 thru 8) met-tile plywood 06/16/2020 n.t.s. step #5 step #6 step #7 step #8
3. Install the End Wall Flashing, trim and notch the flashing to extend past the chimney on the roof, and bend the sides up the chimney. Fasten to the roof. Apply a quality butyl sealant at each corner and up the roof a minimum of 8”. 4. Start the Step Flashing over the End Wall Flashing and apply a quality butyl sealant on each edge of the ...
5/2/2019 Architecture Design Handbook: Architectural Details: Flashings and Copings - Stepped and Chimney Flashings https://www.copper.org/applications/architecture ...
step #9 step #10 step #11 step #12 chimney flashing details (steps 9 thru 12) met-tile plywood 06/16/2020 n.t.s.
