Αποτελέσματα Αναζήτησης
Use Prevailing Torque All-Metal Nut chart if using this style of nut. = Nominal Diameter. = Clamp Load For J429 Grade 5 and 8, FNL Grade 9, A574, Class 4.6, 8.8, 10.9 and 12.9, the clamp loads are listed at 75% of the proof loads specified by the standard. For A307 Grade A, 75% of 36,000 PSI is utilized.
Torque-Tension Relationship for A307A, Grade 5, 8 & 9 Bolts. The torque values can only be achieved if nut (or tapped hole) has a proof load greater than or equal to the bolt's minimum ultimate tensile strength. Clamp load calculated as 75% of the proof load when specified by the standard. ASTM A307 utilized 75% of 36,000 PSI.
The bolt is stressed up to the proofload value, and if there is no deformation, elongation, or fracture, then the bolt is deemed to have passed. For bolting specifications that do not have a published proofload, it is usually calculated at 92% of minimum yield strength.
Tightening Torque Guide for Grade 5 & 8 Hex Cap Screws. This table is based on IFI 5th Edition Technical Data N-12/N-16, using Equation (1) and a torque coefficient, K=0.20 for non plated steel fasteners and K=0.15 for plated fasteners.
The torque values can only be achieved if nut (or tapped hole) has a proof load greater than or equal to the bolt's minimum ultimate tensile strength. Clamp load calculated as 75% of the proof load when specified by the standard. ASTM A307 utilized 75% of 36,000 PSI. Torque values for 1/4 and 5/16-in series are in inch-pounds.
TIGHTENING TORQUE GUIDE based on IFI 5th Edition Technical Data N-12/N-16, using Equation (1) and a torque coefficient, K-0.20 for non-plated steel fasteners and K-0.15 for plated fasteners.
POCKET GUIDE TO TIGHTENING TECHNIQUE. This booklet provides an introduction to the technique of us-ing threaded fasteners for assembling components, the ap-plication of power tools for the assembly and the influence of tool selection on the quality of the joint. 1.
