Αποτελέσματα Αναζήτησης
A guide to sizing condensate lines to and from steam traps, including examples and calculations using the condensate pipe sizing chart.
When sizing the condensate line, take the following three steps: Determine the rate of condensate flow (liquid). Determine the amount of flash steam. Calculate the neglect factor that will allow utility steam to flow freely into the condensate line from failed steam trap stations.
17 Αυγ 2020 · Minimum Condensate Drain Pipe Sizing Chart. Slope to be at least 1/8” per foot or 1 percent, that is for every 12” horizontally there must be at least an 1/8” drop vertically. Condensate drain piping to slope a minimum of 1/8″ per every 12″ horizontal.
Online calculator to quickly determine Condensate Recovery Pipe Sizing for Condensate Recovery Line by Pressure Loss. Includes 53 different calculations. Equations displayed for easy reference.
Condensate pipe sizing. Condensate pipes operate in 4 basic ways: Drain lines to traps. Discharge lines from traps. Common discharge lines. Pumped lines. Types 2 and 3 will usually contain flash steam whilst types 1 and 4 will not.
All steam distribution lines should be installed with a correct slope. Per ASME 31.1 and 31.3, lines that contain a steam/water mix, or require draining periodically, should be pitched downward approx. ½ inch per 10 foot in the direction of flow.
Calculating steam and condensate loads in steam heated systems. Insulated Steam Pipes - Condensate Generated Heat loss from steam pipes generates condensate which must be drained from the system - imperial units.
