Αποτελέσματα Αναζήτησης
To solve the error code 32 on Onan generator, just check and follow the steps below: – Step #1: Check first for the simplest solutions. – Step #2: Check the viscosity of oil. – Step #3: Check spark plugs. – Step #4: Check fuses. – Step #5: Check altitude settings. – Step #6: Check air and fuel filters. – Step #7: Check carburetor. Table of Contents
3 Μαΐ 2023 · Onan fault code 32 is a low cranking speed. What that means is that the RPM level while starting was under 180 for at least 2 seconds. You may be surprised at the sources for this fault code as one is you need to change the oil.
Applicable for supplying power to a constant electrical load for limited hours. Limited-Time Running Power (LTP) is in accordance with ISO 8528. Applicable for supplying power to varying electrical load for unlimited hours.
If the start switch is held down, it runs for the fabled 13 second check and then shuts down with a Code 32. The only item that remains is the starter solenoid, and I'm getting ready to pull it for a bench check and possible replacement.
Disconnect connector P1 (black) from generator set controller and check continuity between Pin 11 and terminal S5+ and between terminal S5- and B- (ground). Repair wiring and connectors as necessary. Test high exhaust temperature switch S5 and replace as necessary. Replace the generator set controller.
9 Σεπ 2019 · Code 32 - Low Cranking Speed This code informs you that your cranking speed is below 180 rpms for 2 seconds. To solve this problem, you need to clean the battery connections, or recharge/replace the batteries or replace the engine oil with the proper viscosity
K19 Series. 600/625 kVA, 480/500 kWe Prime. Reliable Technology and Unmatched Performance.
