Αποτελέσματα Αναζήτησης
Elongate the holes so that the fence support table is approximately level with the top of the band saw table and snug tight the lock nuts. You do not have to fully tighten at this stage, as the shaft will have to be fine- tuned once the fence is fitted.
The drift master can fit on most band saws, either using the existing holes on the side of the band saw table or by drilling two holes. The first part of this manual covers fitting the drift master using existing holes.
View and Download laguna DXIII Driftmaster Fence owner's manual online. DXIII Driftmaster Fence saw pdf manual download. Also for: 110363.
This manual applies to the DXIII Driftmaster fence system. Enter the model number, serial number and purchase information below for quick reference when ordering accessories, supplies or parts. Model: ___________. Serial: ___________. Date of purchase: ___________. Place of purchase: ___________.
3 Αυγ 2007 · Disconnect the fence wires from the terminals and connect jumper wires in their place - one across live and one across ground. Then start the unit up and check the alarm status. If it's...
28 Φεβ 2013 · I installed the 8" fence and took out my engineer's square and checked the blade to the table, then the fence to the table. Everything was square but it seems the fence face has a slight bow in it. I could see light in the middle of the face, top to bottom.
27 Σεπ 2011 · If the fence needs adjustment, elongate one hole and adjust the drift master either up or down, depending on the error. Using the drift master. Adjusting handle on either side of the...
