Yahoo Αναζήτηση Διαδυκτίου

Αποτελέσματα Αναζήτησης

  1. Download schematic symbols, PCB footprints, 3D Models, pinout & datasheet for the PHR-2 by JST Sales America Inc.. 2 Rectangular Connectors - Housings Receptacle Natural 0.079" (2.00mm). Exports to OrCAD, Allegro, Altium, PADS, Eagle, KiCad, Diptrace & Pulsonix.

  2. I did find the JST PH connectors in the Adafruit Eagle library. It looks right, and i'll how it compares to yours. I'll let you know. I'm pretty new to Eagle, and every time i'm forced to spend some time away from it, I end up having to relearn so much.

  3. PH1.0 has a pitch of 1.0mm and PH2.0 has a pitch of 2.0, although there are others. There are usually other distances, like connector height, rated ampacity, and so on. Here's the PH2.0 datasheet that has some drawings that should help:

  4. Looking online to buying some extras and just wondering if JST-PH 2.0 is the same as PH 2.0. The latter of the 2 is listed on the banggood page as the battery connector and the first of the 2 is on the batteries i’m looking at.

  5. It seems like a really poor connection is being made when a fresh battery is plugged in. It can be a known good, fully charged 1S that reads a solid 4.35v on my multimeter, but when I plug it in, telemetry will read something like 3.7v.

  6. There are ramps on the side of the connector that won't allow the grove/seeed cables slide into the connectors. After I shaved/cut off the ramps, to allow them to fit into the connector, I found that the pins are slightly offset in there vertical alignment. This appears to be a custom connector.

  7. 22 Ιαν 2018 · One set holds the wire and the other holds the insulation. Here is a zoom of some of the connectors where you can see the wings. In the picture below you can see that there are two sets of wings. The set in the middle crimps the raw wire. The set that is near the strip is for the insulation.

  1. Γίνεται επίσης αναζήτηση για