Αποτελέσματα Αναζήτησης
7 Ιαν 2021 · PH (2.0mm pitch) This 2.0mm pitch connector is very commonly seen in low cost consumer electronics as well as a plenitude of pre-fabricated hobbyist PCBs and parts. They’re dirt cheap, reasonably compact but not particularly robust. A similar dual row type is also available (PHD) however using different contacts.
12 Φεβ 2013 · Demystify connector types. I have 3 different types of connectors on the batteries that I have for mcx2, 120SR & mcpx. I know the 120SR battery connector type is called JST but not sure if it is the JST-XT or JST-PH type.
16 Δεκ 2022 · The female PH has a wide cut out and two holes at the bottom (2 mm pin spacing), whereas the XH has two slots from the top towards the bottom (2.5 mm pin spacing). Here is an example with 6 pins PH vs XH
5 Φεβ 2021 · I found out that posted library doesn't have right angle type connectors inside. But, on the same website I found this one, and it has a few variant of right angle connectors. https://www.diymodules.org/download/eagle-libs/shr/0000000053/con-JST%20XH.lbr.
5 Φεβ 2021 · Hi there, Does anyone know where can I find Eagle library v7.6 for JST XH 2.54mm right angle connectors (2P, 3P, 4P, 5P and 6P)? Thank you!
The "2.0" refers to the pin pitch, or the measurement between the center of two adjacent pins. PH1.0 has a pitch of 1.0mm and PH2.0 has a pitch of 2.0, although there are others. There are usually other distances, like connector height, rated ampacity, and so on.
This is probably a JST XH (2.5 mm pitch) or PH (2.0 mm pitch), or knockoffs. So start by measuring the pitch and then look at reference photos for connectors of that pitch, paying special attention to the little ridges.
