Αποτελέσματα Αναζήτησης
7 Ιαν 2021 · PH (2.0mm pitch) This 2.0mm pitch connector is very commonly seen in low cost consumer electronics as well as a plenitude of pre-fabricated hobbyist PCBs and parts. They’re dirt cheap, reasonably compact but not particularly robust. A similar dual row type is also available (PHD) however using different contacts.
5 Φεβ 2021 · I found out that posted library doesn't have right angle type connectors inside. But, on the same website I found this one, and it has a few variant of right angle connectors. https://www.diymodules.org/download/eagle-libs/shr/0000000053/con-JST%20XH.lbr.
16 Δεκ 2022 · The female PH has a wide cut out and two holes at the bottom (2 mm pin spacing), whereas the XH has two slots from the top towards the bottom (2.5 mm pin spacing). Here is an example with 6 pins PH vs XH
5 Φεβ 2021 · Hi there, Does anyone know where can I find Eagle library v7.6 for JST XH 2.54mm right angle connectors (2P, 3P, 4P, 5P and 6P)? Thank you!
Looking online to buying some extras and just wondering if JST-PH 2.0 is the same as PH 2.0. The latter of the 2 is listed on the banggood page as the battery connector and the first of the 2 is on the batteries i’m looking at.
JST also makes XH (2.54 pitch, used for balance connextors), and SH (1.25 is common between FC and ESC, 1.0 is also sometimes found on quads to). If you get into fixed-wing or single rotor helis, you'll come across the red "JST" connectors -- these are JST RCY series.
Reviving an old thread as I now think I seek the same as original: According to KiCAD and JST themselves, XH connectors are 2.5mm pitch. However, I see on Amazon many connectors indicated as JST XH 2.54mm pitch. Possibility 1 - These are not JST connectors, and are indeed 2.54 pitch.
